Talking about the Operation Process of Aluminum Cutting Machine
Before 1. work:
1. The aluminum cutting machine power switch, the tightness of the saw blade, the saw blade guard or baffle for detailed inspection, the operating table is stable, and there should be sufficient lighting for night operation.
2. Turn on the main switch of the aluminum cutting machine, make a few turns under no-load test, and then allow it to start after confirmation.
When working 2:
1. It is strictly prohibited to wear gloves. If dust is caused during operation, wear a mask or mask.
2. Do not try to cut smaller workpieces and shorter workpieces that are not clamped.
3. Do not carry out strong cutting saw operation, let the machine idle for more than 10 seconds before cutting to make the motor reach full speed.
4. No one is allowed to stand at the discharge port behind the saw to prevent the short material from flying out and hurting people.
5. Do not leaned over or around the fuselage, and do not perform any operation from the saw blade when it is not stopped.
6. Do not operate when the guard is not in place, and do not place your hands within 15cm from the saw blade.
7. Cut off the power supply before repairing or replacing the aluminum cutting machine parts, and wait for the saw blade to stop.
8. found that there is an abnormal sound, should immediately stop the aluminum cutting machine inspection.
After 3. work
1. Turn off the total power supply of aluminum cutting machine
2. Clean and organize the workbench and site
Company Address
No.16, Jiangong Avenue, Nanfeng Town, Zhangjiagang City
Telephone
Get in touch with us! We will provide you with a great solution!
Copyright©2024 Yuchuan Machinery Co., Ltd. All Rights Reserved.
Powered by:300.cn